Wykamol EP40 Epoxy Floor Coating System – Clear Finish Top Coat 5kg

Product Description

This is part of the Wykamol EP40 Epoxy Floor Coating System consists of the EP40 Epoxy Primer and EP40 Epoxy Top Finish coat. This listing is for the Clear Finishing Top Coat Only so you may also need the Clear EP40 Primer Coat.

Grey EP40 Finishing Coat also available.

This Wykamol EP40 Epoxy Floor Coating System system is fantastic for repairing old damp concrete floors – often laid in the past with no damp proof membrane, instead of hacking up the old floor, relaying the concrete on a new DPM and waiting for it all to dry before covering the floor (which often takes months) you can repair the old floor and install a new surface with self leveller using grip grit to form a key. The savings (depending on the size of floor) can run into thousands of pounds and knock months off your schedules.

After applying the Wykamol EP40 Epoxy Floor Coating System, floors become easier to clean with a hard wearing, dust free, waterproof, impervious finish and are substantially more resistant to damage by chemicals, fuels and lubricants.

Special Features

• Easy to apply
• Excellent adhesion to concrete
• Provides attractive, dust free finish
• Substantially more resistance to chemicals, fuels and lubricants
• Can be used internally and (externally if covered)
• Ideal for areas with high foot traffic
• Can be applied to green concrete after 7 days
• Floor becomes easier to clean with impervious finish
• Typical Coverage: up to 40 m²

Typical Uses

To be used on concrete floors in a variety of domestic, commercial and industrial environments, including:

• Domestic concrete floor slabs
• Industrial plants
• Commercial and retail stores
• Warehouses
• Hospitals
• Showrooms
• Garages
• Gymnasiums
• Food preparation areas

Application

EP40 Epoxy Finish Coat:

1. When using EP40 Epoxy Finish Coat in clear, perform a small test application in an inconspicuous area, to ensure the finish is as desired.
2. One coat of EP40 Epoxy Finish Coat in clear or grey can be applied with a brush or roller, aiming for a continuous coating.
3. Spread the product as thinly as possible while achieveing maximum coverage. Ensure no pooling or excess product remains.
4. Only 1 application of EP40 Epoxy Finish Coat is necessary for areas which will experience light traffic, such as school corridors. 2 coats should be applied in areas of medium traffic, such as warehouses.

Achieving Slip Resistance:

1. Slip resistance can be improved by scattering anti-slip aggregates onto the EP40 Epoxy Finish Coat, whilst still wet, and back rolling at a rate of 75 g/m². Following intial cure (16 – 24 hours), apply a second coat of EP40 Epoxy Finish Coat to secure the aggregates.